Measure Temperature and Humidity using Digilent's Pmod HYGRO
Posted: Wed Mar 03, 2021 10:59 pm
The attached source code shows how to measure temperature and humidity via I2C using Digilent's Pmod HYGRO board.
It was been tested on STMicroelectronics Nucleo-L152RE development board but should work with little or no modification on any of the development boards with I2C that are supported by v7.2 of Astrobe for Cortex M3, M4 or M7.
It was been tested on STMicroelectronics Nucleo-L152RE development board but should work with little or no modification on any of the development boards with I2C that are supported by v7.2 of Astrobe for Cortex M3, M4 or M7.