IDE Terminal Output Behaviour
IDE Terminal Output Behaviour
The IDE terminal only shows output, eg. via 'Out.Char()', only after 'Out.Ln'. In comparison, if I connect to the board using PuTTY, each output shows immediately. Is there a way to configure/change this behaviour in Astrobe?
-
cfbsoftware
- Site Admin
- Posts: 525
- Joined: Fri Dec 31, 2010 12:30 pm
- Contact:
Re: IDE Terminal Output Behaviour
No. The Astrobe terminal is intentionally designed to be simple to use and to work 'straight out of the box' without requiring any configuration.
If more configurability / flexibility is required, terminal emulators that I can recommend are FlashMagic, Teraterm and Syscon - whichever is best suited to the task in hand.
If more configurability / flexibility is required, terminal emulators that I can recommend are FlashMagic, Teraterm and Syscon - whichever is best suited to the task in hand.